What should I pay attention to when using the cleaning ball equipment

The use of cleaning ball equipment is very widespread, but as a machine, we need to pay attention to a lot of problems in the use, let’s learn.

First, after the power, to clean the ball machine debugging, trial operation. Each parameter, such as voltage, current state, thickness and width of production drawing, should be set accordingly, and the set parameters are mainly determined according to the actual production of materials.

Two, clean the ball machine before use must check the connection of the power supply, such as whether the joint connection is loose, whether the line is damaged and open.

The main base material used in the production of the cleaning ball machine is mainly metal material. Metals should be put into the correct operation according to the instructions, the same type or similar performance, etc.

Four, clean the ball machine boot operation work needs to keep in the specified voltage range, that is, requires its voltage in a stable state. If the voltage is too low, the drawing power of the parts with poor quality will be weakened. If the voltage is too high, the electric line may overheat and melt. Therefore, with the installation of equipment should have the corresponding circuit protection device.

Five, in addition, to clean the ball machine timely maintenance and repair, and regularly on its disassembly inspection cleaning dust. Avoid damage caused by dust accumulation problem, or short circuit or short circuit caused by aging of wire due to time problem.

The above is small make up for you to sort out the use of the ball equipment precautions hope to help you, if you have any questions welcome to call to ask.

 


Post time: Sep-15-2020

Subscribe To Our Newsletter

For inquiries about our products or pricelist, please leave your email to us and we will be in touch within 24 hours.

Follow Us

on our social media
  • facebook
  • youtube
  • linkedin
  • twitter